After the FileCloud installation is completed, the following steps will help you prepare FileCloud for use:
- Verify Your Installation.
- Install the FileCloud License.
- Configure the Managed Storage Path.
- Enable MongoDB Authentication.
Verify Your Installation
FileCloud is bundled with a verification tool to help you test your installation. You can run this tool from the server where FileCloud is installed or remotely from a different system. This tool will perform various configuration checks related to your FileCloud environment.
Verification checks are grouped into two categories: basic and extended. It is recommended that you run basic checks at a minimum to ensure that the required components are available to FileCloud. Once the Basic checks pass, Extended checks should be run to verify that required directories and configurations are available.
|Basic Checks||Extended Checks|
|Apache Web Server||CloudConfig.php readable|
|Apache Mod Rewrite||Localstorageconfig.php readable|
|.htaccess Present||Scratch Directory Writable|
|PHP 5.6 or higher||Config Directory Readable|
|PHP MongoDB (mongodb ext) driver 1.2.3 or higher||Mod Rewrite Apache Configuration Setup Check|
|PHP GD Library||PHP Memcache Server (Optional)|
|PHP Zip library||Verification of Mongo DB connection|
|PHP Curl Library|
|PHP OpenSSL library|
|PHP ionCube extension 4.4.1 or higher|
|PHP bcmath extension|
|PHP SimpleXML extension|
|PHP mbstring extension|
|PHP LDAP library (optional)|
|PHP Memcache Extension (optional)|
|Install in Server WWW root folder|
This tool will also report problems so you can correct them before using FileCloud.
All failures reported by the verification tool must be fixed before attempting to use FileCloud.
Running the Verification Tool
To verify your FileCloud installation:
- From the FileCloud server, or the VM instance, open a web browser and enter the following address:
To run verification tests from a system that does not have the FileCloud installation, replace 127.0.0.1 with the IP of the system where FileCloud is installed.
2. To run basic tests, select Basic Checks.
3. To run more thorough tests, select Extended Checks.